Instructions / Assembly

Table Of Contents

INSTALLING THE LED LIGHT KIT

NOTE:

Before starting installation, make sure power is turned off at the circuit breaker.

CAUTION:

The light source is designed for this specific application and can overheat if serviced by

untrained personnel. If any servicing is required, the product should be returned to an authorized

service facility for examination or repair.

Step 1. Remove 1 of the 3 screws from the mounting plate and keep it for future use. Loosen the

other 2 screws. (Do not remove)

Step 2. While holding the LED light kit under the fan motor assembly, make the 2-pin wire

connections: (Fig. 18)

- White to white - Blue to blue

Step 3. Place the key holes from the LED light kit over the 2 screws previously loosened from the

mounting plate, turn light kit until it locks in place at the narrow section of the key holes. Secure by

tightening the 2 screws previously loosened and the one previously removed. (Fig. 18)

Fig 18

MOUNTING PLATE

CONNECTORS

SCREWS

LED

LIGHT KIT