Instructions / Assembly

Table Of Contents

OPERATING THE REMOTE CONTROL/WALL CONTROL

A. 1, 2, 3, 4, 5 and 6 button:

These six buttons are used to set the fan speed

as follows:

1 = minimum speed

2 = low speed

3 = medium low speed

4 = medium speed

5 = medium high speed

6 = high speed

Your DC brushless motor is equipped with a self

learning frequency function remote control.

Restore power to ceiling fan and test the

transmitter as below for proper operation:

Remote Control only: Install two AAA 1.5 volt batteries (included). To prevent damage to transmitter remove the battery if not used for long periods

of time. IMPORTANT: THIS REMOTE CONTROL & DC FAN MOTOR ARE DESIGNED TO PERFORM A ONE TIME SELF CALIBRATION TEST. THIS

IMPORTANT: THIS REMOTE CONTROL & DC FAN MOTOR ARE DESIGNED TO PERFORM A ONE TIME SELF CALIBRATION TEST. THIS

TEST WILL BEGIN ONCE A NEW CODE HAS BEEN SET, AND WILL LAST APPROXIMATELY ONE MINUTES.

fans that feature an UP light ( button) and a

DOWN light ( button) that are controlled

independent of each other;

Press and release the button for the desired light

to turn the light ON or OFF. Press and hold the

button to set the desired light brightness. The

light will cycle between bright and dim settings

as long as the button is pressed. The light key

has an automatic auto-resume feature that

allows the light to remain at the same brightness

as the last time it was turned off.

B. Reverse button:

This button is used to change the direction of

the rotation of the blades; forward for warm

weather or reverse for cool weather.

C. button:

This button turns the power Off to the Fan.

D. Button:

These buttons turn the light ON or OFF and also

control the brightness settings of the light. The

following instructions apply to ceiling fans that

feature a DOWN light ( button) only or ceiling