Installation Guide

Follow the steps below to connect the fan to your house supply wires. Use the wire nuts supplied with your fan. Secure the
wire nuts by wrapping the connection with electrical tape.
Step 1. Disconnect the power and remove the existing wall plate and
switch from the wall junction box.
Step 2. Set the knob of light on the wall control in the - position and
set the knob of speed on the wall control in the O position.(Fig.3)
Step 3. Make wire connections (Fig. 3) and secure with wire nuts
supplied.
• Black wire from fan to black wire from speed control.
• Black/White wire from speed control to black wire from the A/C
supply source.
• White wire from fan to white wire from the A/C supply source.
• Blue wire from fan to blue wire from light control.
• Connect the fan ground wire (green) to the household ground wire.
If your outlet box has a ground wire (green or bare copper) connect the wall control's ground wire to it; otherwise connect
the wall control's ground wire directly to one of the screws from the outlet box.
SUPPLY CIRCUIT
BLACK/
WHITE
BLACK/
WHITE
BLACK
BLACK
BLACK
BLUE
BLUE
BLUE
BLUE
BLACK
GROUND
CONDUCTOR
OUTLET BOX
GREEN GROUND
LEAD
GROUND TO
DOWNROD
GREEN
WHITE WHITE
BLACK
BLACK/
WHITE
INSTALLING THE WALL CONTROL
Remember to shut the power off at the circuit breaker or fuse box.
WARNING: HOOK UP IN "SERIES ONLY" DO NOT CONNECT THE
HOT AND NEUTRAL WIRES OF ELECTRIC CIRCUIT TO THE
WALL CONTROL - DAMAGE TO THE SWITCH AND POSSIBLE
FIRE COULD OCCUR.
1. (Fig. 4) Carefully tuck the wire connections inside the junction
box. Secure the wall control with the two screws provided.
2. Attach the wall plate over the wall control and secure with the two
screws provided.
ELECTRICAL CONNECTIONS
Fig.3
SCREWS
SCREWS
WALL PLATE
SWITCH
OUTLET BOX
OPERATING YOUR FAN
Restore power to ceiling fan and test for proper operation.
1. The fan 4-speed control is used to set the fan speed as follows:
0= Turns the fan off
1= High Speed
2= Medium High Speed
3= Medium Speed
4= Low Speed
2. The” “ button will control the lights, brightness dimmer and off.
Speed settings for warm or cool weather depend on factors such as
the room size. Ceiling height,number of fans, etc.
Fig.4