User guide

8
REMEMBER: To disconnect the power. The fan blades must be already attached to the fan.
Step 1. Remove and discard the center plug from the switch cup. (Fig. 17)
Step 2. Feed the BLACK and WHITE wires from the light kit through the center hole of the switch cup. Thread the switch cup to the nipple on the
light kit. (Fig. 17) Make sure the light kit is securely attached to the switch cup to prevent it from vibrating loose during fan operation.
Step 3. Remove the screws from the switch cup plate. While holding the switch cup, firmly snap the wire molexes together. Next, slide switch cup
up against plate and rotate it until the screw holes are aligned. Secure switch cup to plate using the screws removed earlier. (Fig. 18) Make sure the
connectors are properly connected and that non of the single wires is pushed out of the plastic connectors.
Step 4. Slide the switch cup up over the switch cup plate and rotate until the screw holes are aligned. Secure the switch cup with three screws
previously removed. (Fig. 18) CAUTION: Make sure that the wires are not pinched between the switch cup and the switch cup plate.
LIGHT KIT INSTALLATION