User guide

Fig 18

BULBS

PULL CHAIN

LIGHT KIT

GLASS SHADE

FINIAL

DECORATIVE

COVER

NUT

RUBBER WASHER

WASHER

ATTENTION:

The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt

limiting device. If lamping exceeds 190 watts, the ceiling fan's light kit will shut off automatically.

Step 1. Install 3 x 60w candelabra base bulbs (included).

Step 2. Remove the rubber washer, washer, nut, decorative cover and finial from the light kit. Raise

the glass shade up against the light kit, Place the rubber washer, washer and nut on the top over the

stem and turn it clockwise until it locks up against the glass shade. Do not overtighten. (Fig. 19)

Step 3. Raise the decorative cover and final against the glass shade and secure it to the stem by

turning the final clockwise until snug. Do not overtighten. (Fig. 19)

Note: Make sure to leave enough space between the fan pull chain and the bulbs so the chain doesn't

rub against any of the bulbs.

INSTALLING THE LIGHT BULBS & GLASS SHADE