Installation Guide

ManualsBrandsMinka Lavery ManualsBathroom LightingParadox 2-Light Brushed Nickel Sconce

INSTALLATION INSTRUCTION FOR 1420

For Wall Mount Light Fixtures

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR .

PREPARATION

1. Shut off the power at the fuse box or circuit

breaker. If necessary, remove the old fixture,

including mounting hardware.

2. Carefully unpack your new fixture and lay out all

the parts on a clear area. Take care not to lose

any parts necessary for installation.

MOUNTING THE FIXTURE (Fig.1)

3. Remove the washers (I, J, L, M) and the screw

collar ring (N) from the nipple (H).

4. Secure the crossbar (A) to junction box with

mounting screws (B) (Size: #8-32*0.6”L). The

side of the crossbar marked “GND” must face

out.

5. Thread the nut (D) onto the nipple (E), then insert

the lock washer (C) and thread the nipple (E) into

crossbar (A), then secure with the nut (D).

6. Raise the canopy (F) allowing for the nipple (E)

to protrude through the hole on the canopy (F)

then secure with the finial (G).

CONNECTING THE WIRES (Fig.2)

7. At this point, connect the electrical wires as shown

in figure 2, making sure all wire connectors are

secured. If the junction box has a ground wire

(green or bare copper), connect the ground wire

to it. Otherwise, connect the fixture’s ground wire

directly to the cross bar with the green screw

provided. After wires are connected, tuck them

carefully into the junction box.

COMPLETING THE INSTALLATION

8. Install the light bulb(s) in accordance with the

fixture’s specifications. (DO NOT EXCEED THE

MAXIMUM WATTAGE!) (NE PAS DEPASSER

LA PUISSANCE NOMINALE MAXIMALE!).

9. Slide the iron washer (I), plastic washer (J), glass

(K), plastic washer (L) and iron washer (M) onto

the nipple (H), and secure glass (K) with screw

collar ring (N).

10. Raise the frame (O) allowing for the frame (O) to

protrude through the nipple (H), then secure with

the finial (P).

Your installation is now complete. Return the power

to the junction box and test the fixture.

MIN 75℃ SUPPLY CONDUCTORS

Fig.1

Fig.2

Set#

Crossbar

Ground screw

Mounting screw*2

A 016

Summary of content (1 pages)

PAGE 1
INSTALLATION INSTRUCTION FOR 1420 For Wall Mount Light Fixtures WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER . AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR. PREPARATION 1. Shut off the power at the fuse box or circuit breaker. If necessary, remove the old fixture, including mounting hardware. 2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any parts necessary for installation. MOUNTING THE FIXTURE (Fig.1) 3.