Installation Guide

INSTALLATION INSTRUCTION FOR 1421
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARATION
1. Shut off the power at the fuse box or circuit breaker
box. If necessary. Remove old fixture and all
mounting hardware from wall junction box.
2. Carefully unpack your new fixture and lay out all
the parts on a clear area. Take care not to loose
any small parts necessary for installation.
ASSEMBLING THE FIXTURE
3. Thread the pipe (G) onto nipple (F), pipe (I) onto
nipple (H), pipe (K) onto nipple (J), pipe (M) onto
(L), pipe (O) onto nipple (N), nipple (P) into pipe
(O).
MOUNTING THE FIXTURE (FIG.1)
5. Thread the two mounting screws (A) part way into
the mounting bar (B). Secure the mounting bar (B)
to junction box (not provided) with the junction box
screws (C) through slotted holes in mounting bar
(B).
CONNECTING THE WIRES (Fig. 2)
6. Connect the fixture wires to the junction box wires
as shown in Fig. 2. Make sure all wire connectors
are secure and do not easily pull off with a slight
tug. If there is no Green Ground Wire from the
junction box, connect the Fixture Ground Wire to
the Circular Strap or the Mounting bar with the
Green Screw provided.
7. Tuck these wire connections neatly into the ceiling
junction box.
8. Raise the canopy (D) allowing for the mounting
screws (A) to protrude through the holes on the
canopy (D), then secure with the finials (E).
9. Slide the glass (R) over the socket (Q) and secure
with the retaining ring (S)
COMPLETING THE INSTALLATION
10. Install the proper light bulbs for you fixture.
(DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!) (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
Return the power to the junction box and test the
fixture. Your installation is now complete.
© Minka Lighting, Inc.
This product is protected by United States Federal
and/or State Law, including Patent and/or Copyright
laws.
FIG.1
Fig.2