Installation Guide

INSTALLATION INSTRUCTION FOR 1421-84

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER

PREPARATION

1. Shut off power at the fuse box or circuit breaker

box. If necessary. Remove old fixture and all

mounting hardware from wall junction box.

2. Carefully unpack your new fixture and lay out all

the parts on a clear area. Take not to loose any

small parts necessary for installation.

ASSEMBLING THE FIXTURE

3. Thread the pipe (G) onto nipple (F), pipe (I) onto

nipple (H), pipe (K) onto nipple (J), pipe (M) onto

(L), pipe (O) onto nipple (N), nipple (P) into pipe

(O).

4. Slide the glass (R) over the socket (Q) and secure

with the retaining ring (S).

MOUNTING THE FIXTURE (FIG.1)

5. Thread the two mounting screws (A) part way into

the mounting bar (B). Secure the mounting bar (B)

to junction box (not provided) with the junction box

screws (C) through slotted holes in mounting bar

(B).

CONNECTING THE WIRES (Fig. 2)

6. Connect the fixture wires to the junction box wires

as shown in Fig. 2. Make sure all wire connectors

are secure and do not easily pull off with a slight

tug. If there is no Green Ground Wire from the

junction box, connect the Fixture Ground Wire to

the Circular Strap or the Mounting bar with the

Green Screw provided.

7. Tuck these wire connections neatly into the wall

junction box.

8. Raise the canopy (D) allowing for the mounting

screws (A) to protrude through the holes on the

canopy (D), then secure with the finials (E).

COMPLETING THE INSTALLATION

9. Install the proper light bulbs for your fixture.

DO NOT EXCEED THE SPECIFIED WATTAGE!

Return the power to the junction box and test the

fixture. Your installation is now complete.

FIG.1

Confirmed

Mountain Huang

Minka Group

12/01/04