Installation Guide

MEDALLION INSTALLATION GUIDE
1577-477
1
2
3
Apply polyurethane adhesive on the
back side of the medallion staying
approximately 1” away from edge.
(Polyurethane adhesive not included)
If required, standard or trim head
screws can be used to secure medallion
until adhesive sets. Screw heads should
be recessed. (Screws not included)
If any adhesive runs out during steps 1
or 2, use a wet cloth immediately to
remove the excess.
The medallion is now installed!
4
When you install the lighting fixture,
you may need to replace the threaded
nipple that comes with the lighting
fixture, with the longer threaded nipple
included with the ceiling medallion.