Installation Sheet

INSTALLATION INSTRUCTION FOR 1816
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARATION
1. Shut off the power at the fuse box or circuit breaker
box. If necessary. Remove old fixture and all
mounting hardware from wall junction box.
2. Carefully unpack your new fixture and lay out all
the parts on a clear area. Take care not to loose
any small parts necessary for installation.
ASSEMBLING THE FIXTURE
3. Thread the nut (G) onto the nipple (H), insert the
cap (F), then thread the nipple (H) into the
coupling (E) and tighten with the nut (G).
4. Slide the tube (I), cap (K), iron washer (L), plastic
washer (M), glass (J), plastic washer (N) and iron
washer (O) over the nipple (H) and secure with
the nut (P).
5. Slide the cap (Q) over the nipple (H), insert the
washer (R), and secure with the finial (S).
MOUNTING THE FIXTURE (Fig.1)
6. Insert outlet box screws (B) into the back plate (A),
Secure back plate (A) with outlet box screws (B)
CONNECTING THE WIRES (Fig. 2)
7. Connect the fixture wires to the junction box wires
as shown in Fig. 2. Make sure all wire connectors
are secure and do not easily pull off with a slight
tug. If there is no green ground wire from the
junction box, connect the fixture ground wire to
the circular strap or the mounting bar with the
green screw provided.
8. Tuck these wire connections neatly into the ceiling
junction box.
9. Raise the mounting base (C) over the back plate
(A), and then secure it with machine screws (D)
by wrench.
COMPLETING THE INSTALLATION
10. Install the proper light bulbs for your fixture.
(DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!) (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
Return the power to the junction box and test the
fixture. Your installation is now complete.
Fig.1
Fig .2