Instructions / Assembly

INSTALLATION INSTRUCTIONS

For item#2259 (Rev. 05/27/2013)

READ AND SAVE THESE INSTRUCTIONS

WAR N I N G ! S H U T P O W E R O F F AT F U S E O R CI RC U I T B R E AK E R .

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Fig.1

PREPARATION (Fig. 1)

1. Shut off the power at the fuse box or circuit breaker. If

necessary, remove the old fixture, including the

mounting hardware.

2. Carefully remove the fixture from the carton and check

that all parts are included as shown in the illustration.

INSTALLATION (Fig. 1)

3. Thread the two mounting studs (B) into the pre-drilled

holes in crossbar (A) (You can adjust to length of the

mounting studs if necessary).

4. Attach the crossbar (A) to the outlet box with mounting

screws (C) (size: #8-32N*L0.5”). The side of crossbar

(A) marked ”GND” must face out.

CONNECTING THE WIRES (Fig. 2)

5. At this point, connect the electrical wire as shown in

figure 2, making sure that all wire connectors are

secured. If your outlet has a ground wire (green or bare

copper), connect the fixtures ground wire to it.

Otherwise, connect the fixture ground wire directly to the

crossbar using the green screw provided.

COMPLETING THE INSTALLATION (Fig. 1)

6. Attach fixture body (D) to mounting stud (B) and secure

it with cap nuts (E).

7. Install the light bulb(s) (not included) in accordance with

fixture’s specifications.(DO NOT EXCEED THE

MAXIMUM WATTAGE RATING!)(NE PAS DEPASSER

LA PUISSANCE NOMINALE MAXIMALE!)

8. Secure glass shade (G) to fixture body (D) with ball nuts

(F).

Your installation is now complete. Return power to the

junction box and test the fixture.

Note: Illustration (Fig. 1) on this manual is for installation

purposes only. It may or may not be identical to the

fixture purchased.

LA-2343E

Set# A-016

-Crossbar

-Ground screw

-Mounting Screw*2