Installation Guide

INSTALLATION INSTRUCTIONS
For Model 2303-84 (New. 11/26/2015)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig.1
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off the power at the fuse box or circuit
breaker. If necessary, remove the old fixture,
including the mounting hardware.
2. Carefully unpack your new fixture, lay out all parts
on a clear area. Take care not to lose any small
parts necessary for installation.
3. Attach the circular strap (A) to the outlet box
using the mounting screws (B) (Size:
#8-32N*L0.5”). The side of the circular strap (A)
marked “GND” must face out.
4. Thread the studs (C) into the pre-drilled holes of
the circular strap (A), spaced the same distance
apart as the holes in the back plate (D).
CONNECTING THE WIRES (Fig. 2)
5. At this point, connect the fixture wires to outlet
box wires as shown in Fig. 2, making sure that all
wire connectors are secured. If your outlet box
has a ground wire (green or bare copper),
connect the fixture’s ground wire to it. Otherwise,
connect the fixture’s ground wire directly to the
circular strap (A) using the green screw provided.
After wires are connected, tuck them carefully
inside the outlet box.
COMPLETING THE INSTALLATION (Fig. 1)
6. Align back plate (D) onto studs (C) and secure
with two ball nuts (E).
7. Install light bulb(s) (not included) in accordance
with the fixture’s specification. (DO NOT
EXCEED THE MAXIMUM WATTAGE RATING!)
(NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!).
8. Place glass shade (H) through the bulb (G) and
tighten the glass shade onto socket cup (F) by
twisting it clock wise.
Your installation is now complete. Return power to
the outlet box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-2506E
Fig.2
FIXTURE
WIRES
Black or
Smooth
H
O
USE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
H
O
USE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
H
O
USE
WIRES
Green or
Bare
Copper
(Ground)
Set#
A
-020
- Circular Strap
- Ground Screw
- Mounting Screw*2
A
B
C
D
E
F
H
G