Installation Guide

INSTALLATION INSTRUCTIONS
Item#3294-613 (New. 11/26/2015)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
MOUNTING THE FIXTURE (Fig. 1)
1. Shut off power at the fuse box or circuit breaker. If
necessary, remove old fixture including the mounting
hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Attach the circular strap (A) to the outlet box with the
two mounting screws (B) (Size: #8-32N*L0.5”). The
side of the circular strap marked “GND” must face
out.
4. Thread the studs (C) into the pre-drilled holes of the
circular strap (A) spaced the same distance apart as
the holes in the back plate of the fixture body (D).
CONNECTING THE WIRES (Fig. 2)
5. At this point, connect the electrical wires as shown in
Fig. 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green
or bare copper), connect the fixture’s ground wire to
it. Otherwise, connect the fixture’s ground wire
directly to the circular strap using the green screw
provided. After wires are connected, tuck them
carefully inside the outlet box.
COMPLETING THE INSTALLATION (Fig. 1)
6. Place fixture body (D) onto studs (C) and secure with
cap nuts (E).
7. Place the glass shade (F) over the socket, and
fasten with socket ring (G).
8. Install the light bulb (not included) in accordance with
the fixture’s specifications. (DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
Your installation is now complete. Return power to
the outlet box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA
-
2519
E
FIXTURE
WIRES
Black or
Smooth
HO
USE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Set
#
A
-
020
- Circular strap
- Ground screw
- Mounting Screw*2
Socket ring # SKT-RING-26
F
G
B
D
C
A
E