Installation Guide

ManualsBrandsMinka Lavery ManualsBathroom & Wall LightingMorrow 4-Light Bronze Traditional Vanity Light Bar

INSTALLATION INSTRUCTIONS

Item#3552-588, 3553-588, 3554-588

READ AND SAVE THESE INSTRUCTIONS

W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Fig. 1

Fig. 2

MOUNTING THE FIXTURE (Fig.1)

Shut off the power at the circuit breaker and remove

the old fixture from wall, including the old mounting

hardware.

2. Carefully upack the new fixture and check that all parts

are included as shown in the illustration.

3. Attach the mounting plate (A) to the outlet box using

the outlet box screws (B) (Size: #8-32N*L0

.5”). The

side of the mounting pl

ate marked “GND” must face

out.

CONNECTING THE WIRES (Fig. 2)

4. At this point, c

onnect the electrical wires as shown in

Fig. 2, making sure that all wire connectors are

secured. If your outlet box

has a ground wire (green or

bare copper), connect the fixture’s ground w

ire to it.

Otherwise, connect the fixture’s ground w

ire directly to

the mounting plate using the green s

crew provided.

After wires are connected, tuck them

carefully inside

the outlet box.

FINISHING THE INSTALLATION (Fig.1)

5. Place back plate (D) over mounting plate (A),

fasten

with screws (C) by using Phillips

screwdriver (not

included).

7. Install the light bulb(s) (G) (supplied) in accordance

with the fixture’s specifications. (DO NOT EXCEED

THE MAXIMUM WATTAGE RATING!) (

NE PAS

DEPASSER LA PUISSANCE NOMINALE

MAXIMALE!).

Place the glass shade (H) over socket cup (F). Using

screws (E) secure glass shades to socket cap above

socket cup (F).

Your installation is now complete. Return power to the

junction box and test the fixture.

Note: Illustration (Fig.1) on this manual is for

installation purposes only. It may or may not be

identical to the fixture purchased.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

HOUSE

WIRES

White

(Neutral)

FIXT

URE

WIRES

Green or

Bare

Copper

(Ground)

HOUSE

WIRES

Green

(Ground)

IMPORTANT: FIXTURE SHOULD BE INSTALLED BY

A QUALIFIED ELECTRICIAN TO ENSURE PROPER

WIRING AND INSTALLATION.

Set

-Mounting Plate

-Ground Screw

-Outlet Box Screw*2

A-021-170122

Glass# G3551

This figure is only for referece.

Outlet Box

Summary of content (1 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Item#3552-588, 3553-588, 3554-588 READ AND SAVE THESE INSTRUCTIONS WARNING ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R . AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR. MOUNTING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker and remove the old fixture from wall, including the old mounting hardware. 2. Carefully upack the new fixture and check that all parts are included as shown in the illustration. 3.