Instructions / Assembly

IMPORTANT:
Fixture should be installed by a qualified
electrician to ensure proper wiring and installation.
Dimmable with ELV and/or LED compatible wall
dimmer switches.
INSTALLATION INSTRUCTIONS
FOR
3
8
2/3/4
-
267B
-
L
For Wall Mount Fixture
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
A V E R T I S S E M E N T ! C O U P E R L E C O U R A N T A U N I V E A U D E S F U S I B L E S O U D O D I S J O N C T E U R
.
PREPARATION
1. Shut off power at the fuse box or circuit breaker box. If
necessary remove the old fixture and mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation .
MOUNTING THE FIXTURE (FIG. 1)
3. Remove screws (C) to disconnect mounting back plate (B)
4. Secure mounting back plate (B) to junction box (A) using
junction boxes screws (G) (Size: 8-32*1/2”L). The side of
the mounting back plate marked “GND” must face out.
CONNECTING THE WIRES (FIG. 2)
5. At this point, connect the electrical wires as shown in Fig. 2,
making sure that all wire connectors are secured. If your
outlet has a ground wire (green or bare copper), connect
the fixtures ground wire to it. Otherwise, connect the fixture
ground wire directly to the mounting plate (B) using the
green screw provided. After wires are connected, tuck
them carefully inside the junction box.
FINISHING THE INSTALLATION (FIG.1)
6. Put diffuser G382/383/384-CVR (F) into the bottom of
bracket (D) and then align the glass shade G382/383/384
(E) over bracket (D).
7. Align the fixture over the mounting back plate (B) and
secure with screws (C).
CAUTION /ATTENTION: When handling the fixture, do not
apply pressure to the LEDs. Hold the fixture bracket (D).
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified electrician
without cutting of wire and without damage to any decorative
element to which the fixture is attached. See installation steps
for more details (Fig 3.)
a. Shut off power. Take glass shade G382/383/384 (E) and
diffuser G382/383/384-CVR (F) off bracket (D).
b. Remove screws (H) and gaskets (N) to disconnect clear
glass G382/3/4-LCVR (L).
c. Remove the wires (I) from connector (M) on LED module
(J) by lightly pressing on the release button located on the
top of the wire connector.
d. Carefully remove the screws (K) to disconnect the LED
module (J) from heat sink.
e. Reverse steps a-d for installing the new LED module.
f. Note: The LED module should be provided by a specified
supplier.
g. For better heat dissipation the LED module (J) should be
applied with thermal grease when re-lamping.
FIG.1
SET A#A-021-220105(For 382-267B-L)
SET A#A-021-400105(For 383/4-267B-L)
Back plate
Green screw
Mounting Screws(2
)
Fig 3
Fig.2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper(G
round)