Instructions / Assembly

ASSEMBLING THE FIXTURE (FIG. 1)

1. Shut off the power at the fuse box or circuit breaker. If

necessary, remove the old fixture from the ceiling, including

the existing mounting hardware.

2. Carefully remove the new fixture from the carton and check

that all parts are included as shown in the illustration.

3. Thread the stem (H) into the coupling (G) and secure with hex

nut;

4. Install the bulbs in accordance with the fixture’s specifications.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)

(NE PAS DEPASSER LA PUISSANCE NOMINALE

MAXIMALE!).

5. Insert the plate washer (I), rubber washer (J), shade (K),

rubber washer (J), plate washer (I) over the stem (H) and

secure with hex nut (L) until snug.

6. Insert the cap (M) over the stem (H) and secure with finial (N).

MOUNTING THE FIXTURE

7. Attach the mounting bar (B) to the outlet box using the outlet

box screws (A). The side of the cross bar marked “GND” must

face out.

8. Raise the fixture body to the outlet box.

CONNECTING THE WIRES (FIG .2)

At this point, connect the electrical wires as shown in Fig. 2,

making sure that all wire connectors are secured. If your outlet

box has a ground wire (green or bare copper), connect the

fixture’s ground wire to it. Otherwise, connect the fixture’s

ground wire directly to the mounting plate using the green

screw provided. After wires are connected, tuck them carefully

inside the Junction Box.

Attach the fixture body onto the outlet box by protruding

mounting screws(C) through mounting holes on the canopy (D)

and secure with ball nuts (E).

Your installation is now complete. Return power to the outlet box

and test the fixture.

Fig.1

INSTALLATION INSTRUCTIONS FOR FIXTURE #4387-84

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Set A

020

-Mounting plate

-Ground Screw

Mounting screws (2)