Installation Guide

ManualsBrandsMinka Lavery ManualsLightingTannehill 4-Light Aged Brass Semi-Flushmount Light

INSTALLATION INSTRUCTIONS

Item#4597-575 (New. 11/14/2017)

READ AND SAVE THESE INSTRUCTIONS

WAR NI N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E AK E R .

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Fig. 1

Fig. 2

HANGING THE FIXTURE (Fig. 1)

1. Shut off the power at the fuse box or circuit

breaker. If necessary, remove the old fixture

including the mounting hardware.

2. Carefully remove the new fixture from the carton

and lay out all the parts on a clear area. Take care

not to lose any small part necessary for

installation.

3. Thread screws (A) into the pre-drilled holes in the

circular strap (B) spaced the same distance apart

as the holes in the canopy (D).

4. Attach the circular strap (B) to the Junction box

using mounting screws (C) (Size: #8-32N*L0.5”).

The side of the circular strap marked “GND” must

face out.

5. Secure the rod and canopy assembly (F) onto the

nipple (G) located on the top of fixture body.

CONNECTING THE WIRES (Fig. 2)

6. At this point, connect the fixture wires to the outlet

box wires as shown in Fig. 2, making sure that all

wire connectors are secured. If your outlet has a

ground wire (green or bare copper), connect the

fixture’s ground wire to it. Otherwise, connect the

fixture’s ground wire directly to the circular strap

(B) using the green screw provided. After wires

connected, tuck them carefully into the outlet box.

COMPLETING THE INSTALLATION (Fig. 1)

7. Thread screws (A) into canopy (D), and secure

with knurled knobs (E).

8. Place the candle cover (H) over the socket.

9. Install the bulb(s) (not included) (I) in accordance

with the fixture’s specifications. (DO NOT

EXCEED THE MAXIMUM WATTAGE RATING!).

(NE PAS DEPASSER LA PUISSANCE

NOMINALE MAXIMALE!)

10. Place the glass shade (J) twist to the holder (K).

(In clockwise direction)

Your installation is now complete. Return power to

the outlet box and test the fixture.

Note: Illustration (Fig.1) on this manual is for

installation purposes only. It may or may not be

identical to the fixture purchased.

LA-2858E

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

HOUSE

WIRES

White

(Neutral)

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

Green

(Ground)

Set# A-020

-Circular Strap

-Ground screw

-Mounting Screw*2

Candle Cover#CCV24060P-575

Summary of content (1 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Item#4597-575 (New. 11/14/2017) READ AND SAVE THESE INSTRUCTIONS W ARNING! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R . AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR. HANGING THE FIXTURE (Fig. 1) 1. Shut off the power at the fuse box or circuit breaker. If necessary, remove the old fixture including the mounting hardware. 2. Carefully remove the new fixture from the carton and lay out all the parts on a clear area.