Installation Sheet

Fig.1
- Set #A-010
- Crossbar
-Ground Screw
-Mounting Screw*2
- Rod# W30-H-111*1(G)
W30-1-111*3(H)
-Candle cover#CCV20070P-111(N)
INSTALLATION INSTRUCTIONS
Item#4677-111(New.1/11/2018)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 2
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the fixture from the carton and check that
all parts are included as shown in the illustration.
2. Shut off power at the circuit breaker and remove old fixture
including the mounting hardware.
3. Determine the desired hanging height and thread rods(G,H,)
to the nipple of the fixture body(K). Then attach loop (L) by
screwing in to rod (G).
4. Attach the quick link to loop (L) on the canopy (E), carefully
feed the wire over loop (L) and the canopy(E)
5. The mounting bracket (B) contains several pairs
of threaded
holes, find the pair of holes that match the holes spacing in
your Junction box(J) Attach the mounting bracket (B) to the
Junction Box(J) using the two mountingscrews( size:8/32*
25mm). Tighten the screws (C) securely with screwdriver.
The side of the mounting plate marked “GND” must face out.
6. The support cable is provided to support the weight of the
fixture while wiring. Align the fixture to mounting bracket (B)
and attach hook (M) on the end of support cable into a slot
located on mounting bracket (B). Carefully allow the support
cable to support the weight of the fixture while wiring
CONNECTING THE WIRES (Fig. 2)
7. At this point, connect the electrical wires as shown in (Fig.2),
Make sure that all wire connections are secured. If your
outlet has a ground wire (green or bare copper), connect the
fixtures Ground Wire to it. Otherwise, connect the fixture
Ground Wire directly to the circular strap using the Green
Screw provided.
8. Position the canopy (E)
so that the mounting screws
(D)protruding from mounting bracket line up with the holes in
the canopy. Secure canopy in place with provided mounting
screws (F)
9. Cover all the lampholders with the candle covers（N）.
INSTALL LIGHT BULB (Fig. 1)
10. Install light bulb (I) (included) in accordance with the fixture’s
specifications. (DO NOT EX
CEED THE MAXIMUM
WATTAGE RATING!!) (
NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
FINISH THE INSTALLATION (Fig. 1)
11.Your installation is complete now
. Return power to the
junction box and test the fixture. Note: Illustration (Fig.1) on
this manual is for installation purposes only. It may or
may not be identical to the fixture purchased.
4677-111
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
I
N