Installation Guide

INSTALLATION INSTRUCTIONS
Item#4901/#4902/#4903/#4904-267-L
READ AND SAVE THESE INSTRUCTIONS
WARNI NG! S HUT P OWE R OFF AT F USE OR CI RCUIT BRE AKE R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and remove
the old fixture, including the mounting hardware.
2. Carefully remove the fixture from the carton and
check that all parts are included as shown in the
illustration.
3. Attach the mounting plate (A) to the junction box
using the Mounting screws (B). The side of the
mounting plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
4. At this point, connect the electrical wires as shown
in Fig. 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green
or bare copper), connect the fixture’s ground wire to
it. Otherwise, connect the fixture’s ground wire
directly to the mounting plate using the green screw
provided. After the wires are connected, tuck them
carefully inside the junction box.
FINISHING THE INSTALLATION (Fig.1)
5. Place fixture body (D) over mounting plate (A) and
fasten with Screws (F).+
6. Put the glass shade (E) over the cup (G) and fasten
with Screws (C).+
Your installation is now complete. Return power and
test the fixture.
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Green or
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Set#A022-117117
-Mounting Plate
-Ground Screw
-Mounting Screw*4