Installation guide

ManualsBrandsMinka Lavery ManualsOther5414-281

INSTALLATION INSTRUCTIONS

Item#5414-281 (New. 01/15/2015)

READ AND SAVE THESE INSTRUCTIONS

W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Fig. 1

Fig. 2

MOUNTING THE FIXTURE (Fig.1)

Shut off the power at the circuit breaker and remove

the old fixture, including the mounting hardware.

Carefully remove the fixture from the carton and

check that all parts are included as shown in the

illustration.

3. Position mounting plate (A) on the

wall, and mark

the location of two dry wall anchors (J). Pre-d

rill the

holes for the dry wall anchors. Insert the

dry wall

anchors (J) into the wall.

4. Attach the mounting plate (A) to the junction b

using the Mounting screws (B)

. The side of the

mounting plate marked “GND” must face out.

5. Place the mounting screw (K) through

the keyhole

into the dry wall anchor (J) to secure the Mounting

plate (A) as shown in Fig.1.

CONNECTING THE WIRES (Fig. 2)

6. At this point, c

onnect the electrical wires as shown

in Fig. 2, making sure that all wire connectors are

secured. If your outlet box

has a ground wire (green

or bare copper), connect the fixture’s ground w

ire to

it. Otherwise, connect the fixture’s ground w

ire

directly to the mounting plate using the green s

crew

provided. After the wires are connected,

tuck them

carefully inside the junction box.

FINISHING THE INSTALLATION (Fig.1)

7. Place fixture body (D) over mounting plate (A) and

fasten with Screws (C).

Place the glass shade (F) followed by metal ring (G)

over the socket. Use tool (I) and screw shell (H) to

secure the glass into the fixture body.

9. Install the A19 E26

(MED BASE) light bulb (not

included) in accordance with the fixture’s

specifications.

(DO NOT EXCEED THE MAXIMUM

WATTAGE RATING!) (

NE PAS DEPASSER LA

PUISSANCE NOMINALE MAXIMALE!)

Your installation is now complete. Retur

n power and

test the fixture.

Note: Illustration (Fig.1) on this manual is for

installation purposes only. It may or may not be

identical to the fixture purchased.

LA-2444E

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

HOU

WIRES

White

(Neutral)

FIXTURE

WIRES

Green or

Bare

Copper

(Ground)

HOUSE

WIRES

Green

(Ground)

Socket ring # SKT-RING-26

E26 Socket Spanner: WRH-1-51

Set

220119B

-Mounting Plate

-Ground screw

-Mounting Screw*2

Summary of content (1 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Item#5414-281 (New. 01/15/2015) READ AND SAVE THESE INSTRUCTIONS W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R . AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR. MOUNTING THE FIXTURE (Fig.1) Fig. 1 1. Shut off the power at the circuit breaker and remove the old fixture, including the mounting hardware. 2. Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration. 3.