Installation Guide

ManualsBrandsMinka Lavery ManualsBathroom LightingBelcaro 2-Light Walnut Bath Light

INSTALLATION INSTRUCTIONS FOR 5942-126

For Wall Mount Fixture

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .

MOUNTING THE FIXTURE

Installation (see fig.1)

1.Disconnect power at main electrical panel before

installation.

2. Attach the mounting plate to the junction box using two

junction box screw. The side of the mounting plate marked

“GND” must face out.

3.Guide fixture wires through hole in center of mounting

plate.

4. Follow wiring instructions carefully (see fig.2)

Mount fixture by aligning mounting holes in fixture back

plate with mounting screws and threading ball nuts(E)

onto mounting screws.

6.Attach the glass shade (B) and collar ring(C) on lamp holde

then lock it securely with check ring(D).

7.Install the light bulbs in accordance with the fixture’s

specif ti NOT EXCEED THE MAXIMUM ica ons. DO

AGE RATINWATT G!

Wiring (see fig.2)

1.Connect the electrical wires as follows. Connect the

Black wire from the fixture to the black house (hot)

Wire. Connect the white wire from the fixture to the

white (neutral) house wire. Make sure all wire nuts are

secured. You may wrap the connections with electrical

tape. If your outlet box has a ground wire (green or bare

copper) connect fixture’s ground wire to it. Other wise

attach the bare copper fixture wire to the

green ground

screw on the

mounting plate.

2.Tuck the wire connections neatly into the wall

junction box.

Fig.2

Fig.1

american

lighting

association

Listed

(Hot)

WIRES

Black

HOUSE

Black or

WIRES

FIXTURE

(Ground)

Copper

WIRES

Bare

FIXTURE

(Neutral)

FIXTURE

WIRES

White or

HOUSE

White

WIRES

HOUSE

Green or

Bare Copper(Ground)

Smooth

Ribbed