Installation Guide

INSTALLATION INSTRUCTIONS FOR 6211/6212
For Wall Mount Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
PREPARATION
1． Shut off power at the fuse box or circuit breaker
box. If necessary. Remove old fixture and all
mounting hardware from wall junction box.
2． Carefully unpack your new fixture and lay out all
the parts on a clear area. Take care not to lose
any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
3． Secure mounting Back Plate (A) to the outlet box
using the two junction box Screws (B). The side of
the mounting back plate marked “GND” must face
out.
CONNECTING THE WIRES (FIG. 2)
4． Connect the fixture wires to the junction box wires
as shown in Fig. 2. Make sure all wire connectors
are secured and do not easily pull off with a slight
tug. If there is no green ground wire from the
junction box, connect the fixture ground wire to the
mounting back plate with the green screw
provided.
5． Tuck these wire connections neatly into the wall
junction box.
6． Place the fixture’s Back Plate (C) over the
mounting back plate and secure it with the two
screws (D).
COMPLETING THE INSTALLATION
7． Place the Glass Shade (F) rotation into the Socket
Cup (E) by rotating it to lock.
8. Install the light bulbs in accordance with
fixture’s specifications use TYPE T10 for your
fixture
. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!!)
Return the Power to the junction box and test the
fixture. Your installation is now complete.
MIN 75℃ SUPPLY CONDUCTORS