Instruction manual

Fig 19

INSTALLING THE LIGHT PLATE

NOTE: Before starting installation, make sure power is turned off at the circuit breaker.

1. Remove 1 of 3 screws from the light kit mounting plate and loosen the other 2 screws. (Do not

remove)

2. Raise and hold the light plate close to the light kit mounting plate and proceed to do the wire

connections. Connect the white wire connectors from the light plate and fan, follow the same

procedure with the black wire connectors. (Fig. 19)

3. Place the key holes from the light plate over the 2 screws previously loosened from the light kit

Mounting Plate, turn light plate until it locks in place at the narrow section of the key holes. Secure

by tightening the 2 screws previously loosened and the one previously removed. (Fig. 19).

SCREWS

CONNECTORS

LIGHT PLATE

LIGHT KIT

MOUNTING

PLATE