JAVA XTREME 84"
F754L
INSTALLING THE LIGHT KIT ENJOY YOUR SMART CEILING FAN 3
8 9 0 SUITABLE FOR USE IN WET LOCATIONS
MK1000-BOND RC1000 FAN
3 8. 9. 10. 11. 12. 13. Receiver(9 wire nuts included) A. Mounting hardware: #10x38mm Wood screws(2 pcs.) #8-32x38mm Machine screws(2 pcs.) Lock washers (2 pcs.) 4mm Star washers (2 pcs.) Washers (2 pcs.) B. Blade attachment hardware: 40W LED Light kit PC shade Light kit plate C. Water-proof grommet D. Remote control with holder and 2 mounting screws (1.5V*2AAA battery included) 1/4*16mm+S screw(10pcs) 1/4(Φ 6.6*13*0.
Step 1: Remove the clevis pin and B clip from downrod assembly.(Fig. 5) Step 2: Remove the cross pin and set screw from downrod assembly.(Fig. 6 ) Step 3: Route wires through coupling cover,canopy cover,canopy and hanger ball.(Fig. 7 ) Step 4: Thread the rod into the motor shaft, tighten the set screw,clevis pin, and slip the coupler cover on to the fan body.(Fig.8 & Fig.
Hanger ball Downrod Set screw Hanger ball Cross pin Canopy Canopy cover Downrod Downrod Downrod Coupler Set screw Coupling cover B clip Fan body Clevis pin Coupling cover Wires Cross pin Outlet box Hanger ball Set screw Water proof Grommet Hanger ball Hanger bracket Canopy Washer Star washer Spring washer Screw Canopy B clip Clevis pin Fig.5 Fig.6 Fig.7 Fig.8 Fig.9 Fig.10 Fig.11 Fig.12 Fig.
024 4 (Fig.15) Fig.
Step 2: Motor to Receiver electrical connections: connect the WHITE WIRE from the fan to the WHITE wire from receiver. Connect the RED wire from the fan to the RED wire from the Receiver. Connector the BLUE wire from the fan to the BLUE wire from the recelver. connect the PURPLE wire from the fan to the PURPLE wire from the receiver. Connect the GREY wire from the fan to the GREY wire from the receiver.(Fig.
7 Canopy Canopy Screw Screw 8 Canopy Cover 8 cover 9 Fig.17 Fig.18 Fig.
Assemble the blade onto the motor. Align the three holes of the blades with the motor and tighten them with the screw pack C .(Fig. 20) Blade Washer Screw Fig.
INSTALLING THE LIGHT KIT / Step 1: Remove 1 of 3 screws on light kit adapter and loosen the other 2 screws. (Fig. 21) Step 2: Slide the light kit plate up towards the light kit adapter and place the key holes over the screws on the light kit adapter. Turn light kit plate until it locks in place at the narrow section of key holes.(Fig. 22) Step 3: Align the round hole of the light kit plate with light kit adapter,tighten all 3 screws.(Fig.
Light kit adapter Screw Light kit plate Screw Light kit plate Fig.21 Fig.22 Screw Fig.23 Light kit plate Screw Fig.24 Light kit plate LED module Fig.25 Block Slot LED module Screw Fig.26 Light shade Fig.
9 2pcs AAA battery
28 (CLOCKWISE DIRECTION) (COUNTERCLOCKWISE DIRECTION) 29 Fig.28 Fig.
30 Fig.
60
120 0.11 4.87 42 8.3 10.9 84 120 0.51 32.38 78 3.
6 6,414 4177 4.87 858 8388 32.
