ELLIPSE
©2020 Minka Lighting Inc.Manual design and all elements of manual design are protected by United States Federal and/or State Law including Patents, Trademark , and/or Copyright Laws.
F771L
INSTALLING THE LIGHT KIT ENJOY YOUR SMART CEILING FAN 3
8 9 0
AL-168-1102S RC1000 FAN
A 1 #8-32x38mm Machine screws(2PCs.) B 5 3 4 6 2 Blade attachment hardware: B1. 1/4*13mm+S screw(11pcs) 1/4(Φ6.6*13*0.8mm) flat washer (11pcs) PC B2. #8-18*12mm screw (6pcs) Remote control with holder and 2mounting screws C Balance kit (1.5V*2AAA battery included) D Wire nut(3pcs) 11. Receiver(9wire nuts included) E.
Assemble the blade onto the motor. Align the two holes of the blades with the motor and tighten them with the screw pack B1.(Fig.5)Then, Convert the fan body, have the blade overlap each other and tighten them with the provides screws B2 in parts bag.(Fig.6) SCREW BLADE Fig.5 Fig.
hanger 2 7 8 ,and slip the coupler cover on to the fan body.
Fig.7 Fig.8 Fig.9 Fig.10 Fig.11 Fig.
024 3 (Fig.14) Fig.
Motor to Receiver electrical connections: connect the WHITE WIRE from the fan to the WHITE wire from receiver. Connect the RED wire from the fan to the RED wire from the Receiver. Connector the BLUE wire from the fan to the BLUE wire from the recelver. connect the PURPLE wire from the fan to the PURPLE wire from the receiver. Connect the GREY wire from the fan to the GREY wire from the receiver. Connect Green Black the sensor wire from fan and receiver with the pin-connector.
6 Canopy Canopy Screw Screw 7 Canopy Cover cover 8 Fig.16 Fig.17 Fig.
INSTALLING THE LIGHT KIT / (Do not discard)(Fig.19) 20 Blue to blue Screw back the 3 previously removed screws and tighten the light kit Fig.21 22 Fig.19 Fig.20 Fig.21 Fig.
9 2pcs AAA battery
23 (CLOCKWISE DIRECTION) (COUNTERCLOCKWISE DIRECTION) 24 Fig.23 Fig.
25 Fig.
60
120 0.14 7.13 51 6.3 60 120 0.53 34.13 93 8.6 3.
6 4,593 3165 7.13 444 5854 34.
MKA20021901
