Owners manual

3. Pull manual trim handle out while lifting up on the trim housing until shaft and trim module can be pulled up by hand. (Figure 17)
4. While pulling up on the bracket to release the latch pin, rotate (Figure 18) and pull the lower unit onto the ramps. (Figures 19 & 20)
5. Secure lower unit onto the ramps using the provided emergency strap. The d-ring on the emergency strap can be hooked into the
base as shown (Figure 21). This feature is located on the left side of the motor as viewed from the boat interior. (Figure 22)
Figure 17
Trim Handle
Trim Housing
Figure 21
Figure 22
Figure 19
Figure 18
Figure 20
Figure 20
Figure 21
Figure 22
Figure 19
Figure 18
Figure 20
Figure 17
Trim Handle
Trim Housing
minnkotamotors.com | 33
©2015 Johnson Outdoors Marine Electronics, Inc.
mAnUAL sTOW PROCEDURE