Owner's Manual

Installation Instructions:

1. Remove the four sideplate screws. Remove sideplates to access the mounting holes. (Figure 1)

2. Remove the two 5/16” e-clips retaining the extension damper. Remove the extension damper to expose the front left

mounting hole. (Figure 2)

3. Place the motor on the bow of the boat. It is recommended that the motor be mounted as close to the centerline of the boat

as possible. Make sure the slot on the underside of the mounting base is aligned with the rubrail of the boat. This will ensure

that the shaft has a minimum clearance of 1-1/2” when it is deployed. (Figure 3 & 4)

4. Once the motor is positioned, mark at minimum, four of the six holes that are located farthest apart (at least two on each

side). Make sure the area under the mounting location is clear to drill holes and install nuts and washers. Drill through the

marked holes using a 5/16” drill bit.

Parts Included:

Description Qty.

Screw, 1/4-20 x 2” HH SS 6

Screw, 1/4-20 x 0.5 HH SS 6

Washer-Clipped, 1/4”, 1” OD 6

Nut, 1/4-20 Nylock SS 6

Washer, 1/4” Flat 18-8 SS 6

Washer-Mounting, Rubber 6

Tools and Resources Required:

• Drill

• 5/16” Drill Bit

• 7/16” Wrench

• 9/16” Wrench (for prop)

• Wire Ties (for cable routing)

• Phillips Screwdriver

• Flat Blade Screwdriver

Figure 1 Figure 2

Figure 3 Figure 4

5/16” e-clip

Extension Damper

Align Slot with Rubrail

Side Plate

Side Plate Screws

Figure 4

Figure 1

Figure 3

Figure 2

minnkotamotors.com | 9

4 Johnson Outdoors Marine Electronics, Inc.

InsTALLATIOn