Instruction manual

- 21 -
ATTACHING THE CAMERA BRACKET
ATTACHING AND REMOVING THE METAFLASH UNIT
- 20 -
Align the projection on the
MetaFlash Unit with the hole
on the camera.
Fit the MetaFlash Unit in the
direction of the arrow as
shown until a click is heard.
Attaching the MetaFlash Unit to the Camera
Slide and hold the MetaFlash
Unit release on the bottom
plate of the camera in the
direction indicated and
gently remove the MetaFlash
Unit as shown.
Removing the MetaFlash Unit from the Camera
The CB-3D1 camera bracket stabilizes the positions of the camera body, MetaFlash
unit, and lens unit. Using this bracket is very important when capturing 3D images.
Orient and mount the CB-3D1 camera bracket so that the
positioning pin on the camera bracket fits in the tripod’s
screw hole in the camera body and the mounting screw in
the tripod’s crew hole in the Metaflash unit (see the figure
below).
Turn the mounting screw in
the direction of the arrow
shown in the figure and
secure it in place.
• When removing the camera bracket,
loosen the bracket by turning it in
the direction opposite to the one
that is shown in the left figure.