Service Manual

DRUM UNIT
3-33
III DIS./ASSEMBLY
5.6 Removing and Reinstalling
the Separation Claw
A. Procedure
1. Remove the drum unit from the main body.
2. Remove the drum from the drum unit.
3. Disconnect the relay connector [1].
4. Remove the separation rock spring [2].
5. Remove the 2 positioning screws [3], the 2 col-
lars [4] and the 2 spacer [5], and then remove
the separation claw unit [6].
Note:
• While removing or installing the claw, be careful
to avoid damage to the drum.
6. Pull out the separation fulcrum shaft [2] while
pressing down the claw [1] and remove the 2
separation claws [3].
7. Reinstall the above parts following the removal
steps in reverse.
Note:
• When installing the claw, be sure that it is cor-
rectly oriented and positioned.
• Do not touch the cleaning blade or the drum's
light sensitive areas with bare hands.
[1]
[2]
[3]
[4]
[5]
[6]
[1]
[2]
[3]