Service Manual

I ADJUSTMENT
36 MODE
1-67
3
8.13 List Print
Select the [7. List Print] from the “36 mode menu
screen” to display the list print menu screen.
You can select following menu options from this
screen.
• Test pattern
• Font pattern
• Memory dump list
• Management list
• Adjustment list
• Log list (1)
• Log list (2)
• Analysing list
• E-Mail KRDS com.list
Note:
• Don't try to touch a mode not mentioned.
A. Test pattern
This option is used to output a grid pattern con-
sisted of line width of 2 dots and line-to-line
space of 500 dots. From this pattern, you can
check the write system for normal performance.
B. Font pattern
This option outputs the font list built in the
engine.
C. Memory dump list
This option is used to dump out data (in HEX
and ASCII format) after the address specified in
E-RDH memory (this list is referenced for trou-
bleshooting).
D. Management list
This option outputs the machine status, counter
information and history of jam and so on.
E. Adjustment list
This option outputs a list of current adjusting
values in the 25/36 mode.
F. Log list (1)
The data from the memory is dumped in the
HEX format and the ASCII format. (for analyz-
ing trouble)
Normally not used.
G. Log list (2)
The data from the memory is dumped in the
HEX format and the ASCII format. (for analyz-
ing trouble)
Normally not used.
H. Analysing list
Outputs the necessary list prints together if
trouble occurs in the field. (for analysing trou-
ble)
Normally not used.
(1) Procedure
1. Enter the 36 mode.
2. “36 mode menu screen”
Press the [7. List print] key.
3. “List print menu screen”
Press the key corresponding to the desired
menu option.
4. “List print screen”
When outputting the memory dump list, specify
the start and end addresses.
Note:
• The memory dump list is dump output in both the
HEX and ASCII format.
5. Press the [COPY] key.
6. “Basic screen”
Press the [START] key to output the list.
7. Press the # button while depressing the
∗ button
to return to the list print screen.
8. When outputting another list, repeat above
steps 3 to 7.
9. Press the [RETURN] key to return to the list
print menu screen.
I. E-Mail KRDS com.list
This option outputs the result of the E-mail
KRDS communication.