Instruction manual

CHAPTER 2 : OPERATION GUIDE
124
Other
Functions
2.10.12 Adding a Lens Type/ND Correction
This procedure is available only when the instruments other than the CS-100A are connected to the
computer.
To attach a lens such as a close-up lens and a ND filter, you need to correct the measurement value.
When the CS-100 is connected, for the optional accessory close-up lenses No. 107 and No. 122, their
correction factors are pre-registered with the instrument as “No. 107” and “No. 122”. Other than these,
you can add lens types as “User 1”, “User 2” and “User 3”. Follow the procedure below and register the
correction factor to use for your desired lens, such as the optionally-available ND filter CS-A6 (1/10) or
CS-A7 (1/100), or a combination of the close-up lens and ND filter.
When the CS-2000/2000A is connected
1. Select Instrument - User Calibration from the menu bar.
The User Calibration dialog box appears.
2. To register the correction factor for a close-up lens, click the Write button in the Lens Calibration.
To register a correction factor for an ND filter, select the ND filter to register from the ND Calibra-
tion combo box, and click the Write button in the ND Calibration.
3. Load a file for a correction factor that is already stored in the memory.
4. Click the OK button to start downloading data to the instrument.