Instruction manual

CHAPTER 2 : OPERATION GUIDE
135
Other
Functions
4-1. To perform the level calibration, click the Level Cal button.
The Level Calibration dialog box appears.
4-2. Click the Measure button.
Use the CS-2000/2000A to measure the light source which is used for the level calibration.
The measurement is performed and the data for the level calibration is displayed in a graph.
4-3. Enter the data on which the calibration is based in the target data list on the right and click the Regist button.
The registered target data is displayed in a graph.
By clicking the Load button, you can load the data which is already stored in the memory (file
extension: .lrv) instead of entering data. You can also edit the loaded data. You can save the data
by clicking the Save button (file extension: .lrv).