Instruction manual

CHAPTER 2 : OPERATION GUIDE
25
Starting the
CS-S10w Software
2.1.2 Selecting the Instrument to be Connected
This procedure is available only when the instrument is connected.
1. Select Instrument - Communication Setup from the menu bar.
The Select Instrument dialog box appears.
2. Select the model of the instrument.
When the CS-2000A is connected, select CS-2000.
3. When CS-2000, CS-100A or CS-1000 is selected, click the Comm button.
The Serial Port Settings dialog box appears.
When CS-200 is selected in step 2, communication is established through the USB connection, so
the serial port setting is unnecessary. Go to step 5.
4. Specify the parameters and click the OK button.
If you selected CS-2000 in step 2, USB (CDC) is displayed for Method. [Selection disabled]
For Port, select the COM port to which the CS-2000/2000A is assigned. For the procedure to find
out the COM port number, refer to the installation guide.
Select a COM port that is not currently used by another system or application. Selecting a COM port
that is used by another system or application may result in malfunction.
To specify the parameters, refer to the instruction manual of your instrument so that the parameters
agree with the settings of the instrument.
5. Click the OK button.