Instruction manual

CHAPTER 2 : OPERATION GUIDE
76
Specifying
Target Data/
Tolerance
2.5.3 Setting the Tolerance
To perform judgement based on color difference measurement, it is necessary to set the tolerance.
2.5.3-a Setting the Initial Tolerance
The default tolerance is the value which is automatically set when the target is registered during mea-
surement or other operations. To always perform judgment with the same tolerance, you can specify the
tolerance in advance to save performing the tolerance setting operation every time targets are changed.
1. Select Data - Default Tolerance Setting from the menu bar.
The Default Tolerance dialog box appears.
The colorimetric data items to be displayed (list items) are the items specified with the procedure in
“Setting the List Items” (page 37).
2. Specify the parameters of the tolerance.
When the type of document file is set to the Light-source Color - Contrast Mode measurement,
select White or Black for Group Traits. When the type is set to the Light-source Color - RGB Mode
measurement, select Red, Green or Blue for Group Traits. When the type is set to the Light-source
Color - RGB & Contrast Mode measurement, select White, Black, Red, Green or Blue for Group
Traits. Then,enter the tolerance data for each color.
The specified tolerance is applied to newly added target data.