Instruction manual

CHAPTER 2 : OPERATION GUIDE
90
List Window
Operation
2.6.4 Adding Averaged Data
You can select the desired data from the list data, obtain the average and add the result as new data.
When Multi-Point measurement is specified, the list data cannot be averaged.
1. Right-click the selected (highlighted) list data and select Tool - Average from the displayed context
menu. Or, select at least one piece of list data and select Tool - Average from the menu bar.
A dialog box with the following message appears: “Are you sure to add averaged data?”
2. Click the Yes button.
The averaged data is added to the list.
The averaging calculation performed here first averages spectral data or XYZ data to obtain data
that is then used in the calculation of colorimetric data. On the other hand, the averaging calculation
that uses the statistical values described on page 86 averages the colorimetric data of each piece of
data that was calculated individually according to its spectral data or XYZ data. Consequently, the
results of these two types of calculations may differ.