Service manual

FrameMaker Ver5.5E(PC) CF3102/CF2002 DIS/REASSEMBLY, ADJUSTMENT
02.06.010
D-43
3-2. MECHANICAL ADJUSTMENT
(1) Adjustment of the Scanner Motor Timing Belt
This adjustment must be made in the following case:
The Scanner Motor Assy has been removed.
The Scanner Drive Cables have been rewound.
1. Remove the IR Rear Cover.
2. Remove 11 screws and the reinforcement frame.
3. Loosen the three screws that secure the Scanner
Motor mounting bracket.
4004D188AC
4. With the Scanner drive gear set screw located on
theright-handsideasshownontheleft,slidethe
Scanner Motor Assy to the left and check that it is
returned to the original position by the tension of
the spring. Perform this step three times.
5. Tighten the three screws to fix the Scanner Motor
Assy into position.
4025D132AA
Set Screw