Service manual

FrameMaker Ver5.5E(PC) CF3102/CF2002 DIS/REASSEMBLY, ADJUSTMENT
02.06.010
D-49
(5) Dup. Left Margin
Requirement
This adjustment must be made in the following case:
• The Duplex Unit has been set up.
• The image on the backside of the 2-sided copy deviates in the CD direction.
Adjustment Procedure
1. Load the 1st Drawer with A3 or 11”
× 17” plain paper.
2. Select plain paper on the Paper Type Setting Dial.
3. Select the 1st Drawer.
4. Call the Tech. Rep. Mode to the screen.
5. Touch these keys in this order: “Machine Adjust”
→ “PRT Area” → “Dup. Left Margin.”
6. Press the Start key to let the copier produce a test pattern.
7. Check the dimension of width A on the test pattern.
8. If width A falls outside the specified range, change the setting using the Up/Down key.
• If width A is longer than the specifications, make the setting value smaller than the cur-
rent one.
• If width A is shorter than the specifications, make the setting value greater than the cur-
rent one.
9. Press the Start key to let the copier produce a test pattern.
10. Check the dimension of width A on the test pattern.
11. If width A is outside the specified range, change the setting again and make a check
again.
12. If width A falls within the specified range, touch “END.”
13. Following the same procedure, adjust for all other paper sources.
Specifications Adjustment Mode Setting Range
3.0
± 1.0 mm Dup. Left Margin -3.0 mm to +3.0 mm
Width A on the test pattern produced should fall
within the following range.
4004D512AA
Width A