Service manual

FrameMaker Ver5.5E(PC) CF3102/CF2002 DIS/REASSEMBLY, ADJUSTMENT
02.06.010
D-62
(17) Fuser Temp.
This adjustment must be made in the following case:
• Fusing performance is poor or offset occurs when the paper type or environmental condi-
tions are changed.
Adjustment Procedure
1. Call the Tech. Rep. Mode to the screen.
2. Touch these keys in this order: “Machine Adjust”
→ “Fuser Temp.”
3. Select the paper type and Fusing Roller type.
4. Enter the new setting from the 10-Key Pad.
If fusing performance is poor, increase the setting.
The temperature does not change immediately when the setting is change. Wait a while
before performing the subsequent steps.
5. Touch “END” to validate the adjustment value.
6. Check the copy image for any image problem.