Service manual

FrameMaker Ver5.5E(PC) CF3102/CF2002 DIS/REASSEMBLY, ADJUSTMENT

02.06.010

D-74

4-4. REMOUNTING RAM IC (IC202)

1. Remove the Image Control Board (PWB-F) from the copier.

2. Remove RAM IC (IC202) from the old Image Control Board (PWB-F).

3. Remove RAM IC (IC202) from the NEW Image Control Board (PWB-F) and then install

the RAM IC (IC202) from the old Image Control Board (PWB-F) on the NEW Image

Control Board (PWB-F).

NOTE

• If the Image Control Board (PWB-F) has been replaced and RAM IC (IC202) is not to be

remounted, be sure to record all data of Utility mode and Tech. Rep. mode functions and

make the entries again of these numeric values.

4025D137AA

NOTE

• Note the alignment notch (A) on RAM IC

when mounting it.