Service manual

FrameMaker Ver5.5E(PC) CF3102/CF2002 SWITCHES ON PWBs/TECH. REP. SETTINGS
02.06.05
S-32
Item Purpose Setting/Precautions
Jam
To check the number
of misfeeds that have
occurred at different
locations in the copier
or to clear the count of
each counter.
• To clear the count of a counter, select the spe-
cific part and press the Clear key.
• If a counter is cleared mistakenly, press the
Interrupt key, which will undo the clearing opera-
tion.
Trouble
To check the number
of malfunctions that
have occurred at differ-
ent locations in the
copier or to clear the
count of each counter.
• To clear the count of a counter, select the spe-
cific part and press the Clear key.
• If a counter is cleared mistakenly, press the
Interrupt key, which will undo the clearing opera-
tion.
Warning
To check the number
of warning conditions
detected according to
the warming type or to
clear the count of each
counter.
• To clear the count of a counter, select the spe-
cific part and press the Clear key.
• If a counter is cleared mistakenly, press the
Interrupt key, which will undo the clearing opera-
tion.
• When a warning condition occurs, an oil mark
appears at the lower left corner of the Basic
screen.
• Touching the oil mark will display the warning
code screen.
Maintenance
To set a count value
for maintenance of any
given part.
When any given part
is replaced.
<Maint.-Set>
• Enter the maintenance counter value from the
10-Key Pad.
<Maint.-Count>
• Counts up when a sheet of paper is fed through
the copier. Pressing the Clear key will clear the
count.
• If the count is cleared mistakenly, press the
Interrupt key, which will undo the clearing opera-
tion.