Service manual

FrameMaker Ver5.5E(PC) CF3102/CF2002 TROUBLESHOOTING
02.06.13
T- 2 9
(12) Fusing/Exit Misfeed
<Detection Timing>
<Action>
Type Description
Fusing/Exit misfeed
detection
The Exit Sensor (PC10) is not unblocked even after the lapse of a
given period of time after it has been blocked by the paper.
The Duplex Unit Transport Sensor 1 (PI1) is not blocked even after
the lapse of a given period of time after the Exit Sensor (PC10)
has been unblocked by the paper during a switchback sequence.
Detection of paper left
at Fusing/Exit
The Exit Sensor (PC10) is blocked when the Power Switch is
turned ON, a door or cover is opened and closed, or a misfeed or
malfunction is reset.
Relevant Electrical Parts
Exit Sensor (PC10)
Duplex Unit Transport Sensor 1 (PI1)
IO Board (PWB-IO)
Step Action Ref. Page
WIRING DIAGRAM
Control Signal
Location
(Electrical
Component)
1 Initial check items T-12 ——
2 PC10 I/O check T-4 to T-10 — 8-F
3 PI1I/Ocheck T-4toT-10 — 4-H (AD-14)
4 Change PWB-IO. —— —