Service manual

FrameMaker Ver5.5E(PC) CF3102/CF2002 TROUBLESHOOTING
02.06.13
T- 4 4
(22) C0096: Image Transfer Belt pressure/retraction failure
<Detection Timing>
<Action>
Malfunction Code Description
C0096
• The1stImageTransferRetractionPositionSensorisnotacti-
vated (retracted position) within 3 sec. after the 1st Image Trans-
fer Pressure/Retraction Motor has started turning during a
sequence of the Transfer Belt's retracting motion.
• The 1st Image Transfer Retraction Position Sensor is not deacti-
vated (pressed position) within 1 sec. after the 1st Image Trans-
fer Pressure/Retraction Motor has started turning during a
sequence of the Transfer Belt's pressing motion.
Relevant Electrical Parts
1st Image Transfer Retraction Position
Sensor (PC28)
1st Image Transfer Pressure/Retraction
Motor (M11)
IO Board (PWB-IO)
Step Action
Ref.
Page
WIRING DIAGRAM
Control Signal
Location
(Electrical
Component)
1
Check the M11 connector for
proper connection and correct
as necessary.
—— —
2 PC28 I/O check
T- 4 t o
T- 1 0
— 5-E
3 M11 operation check T-3
PWB-IO PJ16IO-1 to 4
(Pulse Output)
5-D
4 Change PWB-IO. —— —