Service manual

FrameMaker Ver5.5E(PC) CF3102/CF2002 TROUBLESHOOTING
02.06.13
T- 9 7
(20) Printer Monocolor: void areas, white spots
<Typical Faulty Images>
<Troubleshooting Procedure>
Section Step Check Item Result Action
Image
Check
1 There are void areas at the
front side or high density sec-
tion.
YES
T- 9 1
2 There is void area at the rear
side section.
YES Perform “2nd Transfer Adjust”
of “Image Adjust” under Tech.
Rep. mode.
IU 3 The surface of the PC Drum is
scratched.
YES Change Imaging Unit.
4 Dirty on the outside. YES Clean.
Hopper Unit 5 Foreign matter or caked toner
in the Toner Cartridge.
YES Remove foreign matter.
6 The problem has been elimi-
nated through the checks of
steps up to 5.
NO Change IU.
Void areas White spots
4011T008AA
4011T030AA