Service manual

FrameMaker Ver5.5E(PC) CF3102/CF2002 TROUBLESHOOTING
02.06.13
T-1 11
Image
Adjust
→Stabilizer
→Reset +
Stabilizer
(Tech. Rep.
Mode)
9 After the Reset + Stabilizer
sequence has been com-
pleted, run Gradation Adjust; if
the problem persists, make
adjustments of PRT Max Den-
sity and PRT Highlight.
NO Go to next step.
10 The problem has been elimi-
nated through the checks of
steps up to 9.
NO Change Image Transfer Roller
Unit.
→Change Image Transfer
Belt Unit.
→Change PIC Board.
→Change High Voltage Unit
(Developing Bias).
→Change High Voltage Unit
(Image Transfer, Neutralizing).
Section Step Check Item Result Action