Service manual

FrameMaker Ver5.5E(PC) CF3102/CF2002 MAINTENANCE
02.06.05
E-24
Reinstallation Procedure
NOTE
• When installing the Imaging Unit, ensure that the color of the mounting guide of the
Imaging Unit is the same as the color of the label at the mounting position on the main
unit.
1. Remove the Imaging Unit from its aluminum
pack.
2. Tilt the Imaging Unit to the left and shake it a
small stroke in the tilt direction twice. Then, tilt it
to the right and shake it a small stroke in the tilt
direction twice.
NOTES
• Since the Imaging Unit is highly susceptible to
light, keep it shielded from light up to the time it is
installed.
• Carefully unseal the aluminum pack.
• If the Imaging Unit is packed in the aluminum pack-
age again, seal the package using tape or another
means.
4025U024AA
3. Remove the protective tapes
C4587U013AA
protective tape
4. Remove the shipping cushion.
CAUTION
• Makesurethattheprotectivesheetisrolledupinto
the Imaging Unit as shown in the <OK>.
<OK>
<NG>
protective
sheet
C4587U015AA
protective sheet
5. Keeping the Imaging Unit in a level position,
insert the Imaging Unit into the mounting position
all the way until it is stopped.
NOTE
• Do not allow the Imaging Unit to become tilted
while installing them into the Main Unit, as damage
to the PC Drum or the LED assembly can result.
4025U028AC