Service manual

FrameMaker Ver5.5E(PC) CF3102/CF2002 DIS/REASSEMBLY, ADJUSTMENT
02.06.010
D-3
2. DISASSEMBLY/REASSEMBLY
2-1. DOORS, COVERS, AND EXTERIOR PARTS:
IDENTIFICATION AND REMOVAL PROCEDURES
No. Name Removal Procedure
1 Original Glass
Remove the IR Upper Right Cover.
→ Remove one screw and the
Original Glass fixing brackets (front and rear).
→ Remove the Origi-
nal Glass.
2
IR Upper Right
Cover
Remove three screws and the IR Upper Right Cover.
3 Control Panel
Remove the four caps on both sides of the control panel.
→
Remove four screws and the flat cable. → Remove the control
panel.
4 IR Front Cover
Remove the IR Lower Front Cover.
→ Loosen three screws and
remove the IR Front Cover.
5
IR Lower Front
Cover
Remove the pipe ends (left and right).
→ Remove two screws and
the IR Lower Front Cover.
6 IR Left Cover
Remove the IR Upper Cover.
→ Remove the IR Rear Cover. →
Demount the IR Unit from the Copier Stand. → Remove four screws
and the IR Left Cover.
7
IR Upper
Cover
Remove the Original Cover.
→ Remove six screws and the IR
Upper Cover.
8 IR Rear Cover
Disconnect the power cable and ADF cable.
→ Remove the IR
Upper Cover.
→ Remove two screws and the IR Rear Cover.
9 IR Right Cover
Remove the IR Upper Cover.
→ Remove the IR Rear Cover. →
Demount the IR Unit from the Copier Stand. → Remove four screws
and the IR Right Cover.
1
3
4
5
6
7
8
9
2
4025D003AA
4025D004AA