Service manual

FrameMaker Ver5.5E(PC) CF3102/CF2002 DIS/REASSEMBLY, ADJUSTMENT
02.06.010
D-8
(1) Removal of the CCD Unit
1. Remove the Original Glass.
2. Remove 14 screws and optical cover.
4025E006AB
3. Remove the Image Processing Interface Board
cable from the CCD Unit.
4025D113AA
Image Processing
Interface Board
4. Unplug connector
4025D114AA
5. Remove four screws and the CCD Unit.
NOTE
• Make doubly sure that you remove the correct
screws. If any screw that should not be removed is
removed, it results in the distance between the
lens and the CCD sensor or tilt in these parts being
varied.
4025D115AA