Service manual

FrameMaker Ver5.5E(PC) CF3102/CF2002 DIS/REASSEMBLY, ADJUSTMENT
02.06.010
D-25
7. Wind the hook end of the cable around the pulley
five turns counterclockwise, from the rear toward
the front side.
NOTE
• Make sure that no part of the cable rides on the
other.
4025D053AB
8. Slip the Cable Holding Jig onto the pulley to
secure the cable in position.
4025D054AB
9. Install the front and rear pulleys and bushings
onto the shaft and fit the C-clip.
4025D056AA
10. Mount the Scanner drive gear on the shaft and
secure it using one screw.
NOTE
• Allow a clearance of about 0.1 mm between the
Scanner drive gear and bushing.
4025D057AA
4025D059AA
0.1 mm