Instruction manual

3736
Cancel data number imprinting when the film will be loaded
multiple times (Mid Reload).
• The data number is recorded even if it is not imprinted.
Cancelling Data Number Imprinting
Cancel data number imprinting before load-
ing the film.
• The data number is imprinted when the film is loaded.
1. Press the MODE and +
buttons until
appears in the DM-9 data
panel.
• will blink in the data panel.
2. Press the + or – button
to select .
• will blink in the data
panel.
3. Press the MODE button
or press the shutter-
release button partway
down to enter the
selection.
• The data number will not be
imprinted until is
selected or the DM-9’s battery
is replaced.
DATA NUMBER
The data number is displayed in the DM-9’s data panel
after the back is closed when loading a new roll of
film.
Data Number
When the DM-9 is mounted, the Data Number is automatically
imprinted when film is loaded into the camera.
• The data number is imprinted even if a SmartMedia card is not
loaded.
Imprinting
• ▲ blinks under PRINT for 4
seconds when the data
number is imprinted.
• Data numbers start from 0001 and go to 9999. After 9999, the
data number resets to 0000 then cycles from 0001 to 9999
again.
• Press the camera’s DATA button to confirm the data number.
DM9E 12/15/98 11:37 AM Page 36