Service manual

FIXING UNIT
1-O-4
3 DIS./ASSEMBLY1 DIS./ASSEMBLY
(9) Reinstall the above parts following the removal
steps in reverse.
Caution:
When installing the lamps, pay atten-
tion to their orientation. The size of the
lamp terminal mounting hole in the
front lamp fixing plate is different from
that in the rear lamp fixing plate. The
lamp cannot be installed properly if it
is facing the opposite direction.
[6] Replacing the Fixing Heater
Lamp(L4)
Caution:
Do not touch the fixing heater lamp with
bare hands.
Caution1:
Install the heater lamp with the man-
ufacturers mark facing the rear.
Caution2:
The heater lamp should not touch
the inner surface of the upper roller.
Caution3:
When replacing the heater lamp, be
sure to insert the lamp end in the
lamp terminal securely. Also, check
that the Faston terminals are con-
nected properly.
a. Procedure
(1) Open the fixing cover (upper).
(2) Remove the screw at front to remove the lamp
fixing plate (lower front).
(3) Remove the Faston terminal.
Screw
Faston
Lamp fixing plate (lower front)